Step Two: Step Three: Step Four: Call or email with any additional questions!
Step One:
Wipe surface clean with solution (denatured alcohol)using a soft cotton cloth
With glue gun hot (usually 3-5 min. to warm up), Apply dent-adhesive liberally to pull foot (careful not to burn fingers!). Be sure to bring glue up and over top of foot to increase pulling strength
Place foot into dent. Do not press hard. Blow on adhesive to increase curing time and let go when set (usually 10 seconds). Wait 3-5 minutes and place bridge over foot. Be careful not to jar or move foot when placing bridge over pull foot. Screw down dial, and turn down as fast as possible until it releases.
Remove glue immediately after pull with solution. Examine area for results. If it is mounded high, use plastic tap down and push down gently. IF dent is still low, repeat until satisfactory.